How To Do Rockspace Local Setup On re.rockspace.local?

Whether you are looking for Rockspace repeater setup or rockspace local setup, you will be redirected to re.rockspace.local only. This is because it is the official website for Rockspace extender setup. So, if you are looking for the same, then this is your shot. Here, you will find the right way to set up and log in to Rockspace local.

Easy Steps For Rockspace Extender Setup Via WPS Button -
Follow the below-mentioned steps to set up your Rockspace wifi extender using the WPS button on your router and extender.
  • First of all, take a pointed object like a pin or a pen and find the reset button on the wifi extender and then press it.
  • To begin the connection, plug your Rockspace wifi extender close to the wifi router to remove any obstructions from between.
  • Now, enable the power supply for both the devices; the extender, and the wifi router.
  • After the Rockspace wifi extender is on, push the WPS button on it and then look for the green light to turn steady
  • The stable LED light implies that the connection has been established. 
  • Once it is done, you may plug the Rockspace wifi extender anywhere in the house. 
  • Ensure to place the wifi extender somewhere in the network dead zone area to have the network range there.
  • Then, you must visit the official website for rockspace wifi extender setup i.e. re.rockspace.local to access the admin settings.
  • Now, you must enter the login information for your wifi extender on the web setup page of the extender. This will open the admin panel and you can configure the settings.
  • Now you must connect your computer or laptop to the Rockspace wifi extender’s network.
  • Finally, you have to check whether the connection between the extender and the wifi router is properly established or not. 

Easy Step For Rockspace Extender Login - 

Follow the steps mentioned below to perform Rockspace local login easily;
  • Start by inserting the Rockspace wifi extender into an electrical wall socket close to the wifi router.
  • Connect the router and wifi extender with the help of a CAT5 ethernet cord.
  • Now, turn on both devices.
  • Next, you have to launch the web browser and go to the web page of the Rockspace wifi extender login and setup.
  • In case you can’t access http://re.rockspace.local, then use the default IP address mentioned at the back of the extender.
  • Now, you will be taken to the admin settings of the wifi extender. Here, you can make any desired settings for the router.
  • Check the speed of the connection by linking your computer or laptop to the extended network.
  • Tada! Your re.rockspace.local login is complete and you can now manage your extender’s settings anytime.
Rockspace Wifi Extender Set Up!

After following the instructions given above you will be able to complete re.rockspace.local setup. Now, you can log into the extender’s admin interface and check the network and firmware status whenever required. Modify the login settings and other network settings according to your preference.

Comments

Popular posts from this blog

A Quick Guide To Complete Rockspace Extender Setup

Guide on How to Set Up Rockspace Wifi Extender

3 Ways To Complete Rockspace Extender Setup